Punch safety protection and control device can open

As the topic? The answer is no: punch safety protection and control device shall not be any open. Check the press brake machine the transmission, connections, lubrication and protection insurance device is normal, in areas such as the filling mold screw must be strong, cannot be moved. Press should be 2 - short run before work 3 minutes, check the foot brake control devices such as flexibility, confirmed rear can normal use, shall not take a disease. using motor drive pulley, drive belt drive pulley turn the passive, active, active crankshaft pulley, which in turn affects the use of reverse rotation of the crankshaft crankshaft gear drive to promote active stamping, the crankshaft by the initiative of the crankshaft and at the same speed reverse rotation, and the four groups of crank connecting rod drive on which the synchronous movement, under the affect of the four connecting rod shaft by sliding a device of 2 below the connection mode of activities, and in the below four connecting rod repeated movement, push up and down reciprocating sliding punch in the upper die and lower die and mold by stamping sheet in which the relative motion. in order to improve the precision press brake machine service life, must avoid direct sunlight and other heat radiation, but also avoid too wet, too much dust or corrosive gas. Corrosive gas is easy to make electronic components is corrosive and metamorphism, lead to poor contact phenomenon or short circuit between components and affect the normal operation of the CNC punch press. Mould when matter is firm, upper and lower die for, ensure correct position and turn to move by hand press try to rush, Empty) To ensure the work in the mould is in good condition. Before driving to pay attention to lubrication, remove the press brake machine on all of the items. To stop at the end of the work in time, cut off power supply, wipes machine, tidy environment.
punch safety protection and control device of note
punch safety protection and control equipment, may not be artificially open. Check the punch the transmission, cohesion, smooth and protective insurance in areas such as the equipment is normal, filling mold screw is necessary, cannot be moved. in the job should be done before 2 - empty your homework 3 minutes, see the foot brake control equipment such as flexibility, admitted to rear can normal use, shall not take a disease. Mould when matter, upper and lower die for, to ensure correct orientation, turn to move by hand press try to rush, Empty) To ensure that in the mold in outstanding cases. Before driving to pay attention to smooth, remove the punch to remove all of the items. Homework at the end of the parking in time, the detection power, wipes machine, clean environment.
Looking for an innovative range of metal shearing machine Solution products? Foshan Ragos NC Equipment co.,LTD. supplies a diverse range of consumer, commercial and specialty industrial products including Solution, cnc hydraulic press brake, hydraulic bending machine,etc.Click Ragos Press Brake Machine to learn more!
Foshan Ragos NC Equipment co.,LTD. would like to provide our customers with as near perfect protection, as near perfect service as is humanly possible and to do so at the lowest possible cost.'
Although there are various available in the market (such as sheet metal press machine, small press brake, and sheet metal equipment), recent study results have made this hydraulic shearing machine Solution a preferred Solution choice of the people.