Manufacturer : Panel Bender    Press Brakes             Sales Contact : JACK HE              Tel :  +86-135-1658-9668            Email to : heweisheng@ragoscnc.com

PROVIDE CUSTOM EDITING

Different punch bearing installation and use of the method

by:Ragos     2021-06-26
Bearing many varieties, each bearing have different equipment and the use of different method. Will come here and we talk about different bearings from the device using the method, fast and small make up take a look at the detailed. Trust through the introduction of this article, we have different bearing equipment use method also have further understanding. Deep groove ball bearing equipment use 1. Equipment bearing force uniform, should not directly hammer. Such as: cooperation interference is bigger, bearing should be on active air heating furnace temperature control or oil heating furnace, heating temperature strict control in 120 & deg; The following. 2. Equipped with nylon stick to frame bearing can be - 40° - 120° Have safe operation for a long time, in 150 & deg; Homework should not surpass 4 hours, when the time is short peak temperature should not exceed 180 & deg; 。 3. Stop check bearing the warehouse should be clean, dry, a storage with chemical products should not exceed 65% relative humidity, and stop bearing ground storage. 4. Inventory bearing clean every other year shall be from the beginning, the rustproof packaging. Use 1 horn touch ball bearing equipment. Equipment bearing force uniform, should not directly hammer. Such as: cooperation interference is bigger, bearing should be on active air heating furnace temperature control or oil heating furnace, heating temperature strict control in 100 & deg; The following. 2. Equipped with nylon stick to frame bearing can be - 40° - 120° Have safe operation for a long time, in 150 & deg; Homework should not surpass 4 hours, short time when the peak temperature can reach 180 & deg; 。 3. Stop check bearing the warehouse should be clean, dry, a storage with chemical products should not exceed 65% relative humidity, and stop bearing ground storage. Self-aligning roller bearing equipment use 1. Users should be selected according to the requirements of using appropriate cooperation and the strength to the clearance of bearing. Please correct bearing code after unpacking. 2. In front of the bearing equipment, if need to add grease in the bearing, oil is necessary to clean, right amount. 3. Equipment not directly within the hammer, outer end face and roller advisable, to avoid crack in the inner ring or, small guard. Often users should put the bearing into the mineral oil in heated to 90 & deg; - 100° Immediately on the spindle. Avoid by all means is adopted for bearing part of the burner method, the difficult to & other; Hot charging & throughout; Users should also be used when special socket device. 4. Bearing used in dust should have excellent sealing device and smooth, not oil. 5. Bearing the warehouse should be clean and dry, no environmental pollution, bearing accumulation is not fall to the ground, packing without damage. Stock over 1 year bearing from wash oil is necessary. Thrust spherical roller bearing equipment use 1. Equipment should be put the bearing oil seal bearing wash again with a clean smooth oil quality. 2. Bearing, the equipment should be uniform stress, can't hammer. Such as interference of cooperation is bigger, should put the bearing into the mineral oil in heated to 90 & deg; - - - - - - 100° And promptly equipment. 3. Check bearing the warehouse should be clean, clean, are no more than 65% relative humidity. 4. Inventory bearing every other year should be cleaned from oil, oil seal packaging adhere to outstanding. 5. Should be distinguished when using bearing seal dust equipment, and should often check the homework. Hope the above bring you help.
Custom message
Chat Online
Chat Online
Leave Your Message inputting...
business@ragoscnc.com