In the CNC bending machine maintenance or need to do the preparation before wiping

On CNC bending machine maintenance or wipe machine needs to be done before the preparation of CNC bending machine bending stress adjustment solution 1, bending machine, pressure is calculated according to the tensile strength calculation sheet. Sheet if your performance is not the same, although the calculated, but the actual force to nature is not the same. 2, if the outside factors, it's just a matter of bending machine, can adjust through the two places, one is the adjustment in the system panel to tensile strength, 2 it is to adjust the system Settings of DA values. Appear this kind of problem is not necessarily completely is not normal, overload, over a long period of time or an external power supply is not stable, or machine parts of friction increases are likely to lead to this phenomenon, must pay attention to maintenance. Before bending machine maintenance or brush machine, should turn off the upper die alignment after lower die down, until the work is completed, if you need to boot, or other operations, should will choose in manual mode, and to ensure safety. Its maintenance content is as follows: 1, the hydraulic circuit check the tank oil level weekly, such as hydraulic system also should check after repair, oil level is lower than the oil window should include hydraulic oil; This machine is used for the hydraulic oil for ISOHM46 or MOBILDTE25; New work 2000 hours after the oil should be replaced, later every work of 4000 ~ 6000 hours after the oil should be replaced, the oil change every time, should be cleaning tank; System oil temperature should be between 35 ℃ ~ 60 ℃, shall not exceed 70 ℃, such as too high will lead to damage of metamorphic oil and accessories. 2 every time, filter oil change, filter should be replaced or cleaned thoroughly; Associated with the machine alarm or clean oil filter and other abnormal, should be replaced; Tank on the air filter, clean every three months to check, best 1 year replacement. 3, hydraulic parts monthly cleaning hydraulic parts ( Base board, valve, motor, pump, tubing, etc. ) , prevent dirt from entering the system, cannot use cleaner; Phone use after a month, check whether there is any deformation on the oil pipe bend, if there is any exception should be replaced, use two months later, should tighten the joint of all parts, for the work should be shut down, when the system pressure.
Most people who see a in operation for the first time are amazed at how well the hydraulic bending machine is managed.
Super quality are in offer at Ragos Press Brake Machine, welcome to visit us.
Diversifying is an excellent growth strategy, as it allows Ragos to have multiple streams of income that can often fill seasonal voids and, of course, increase sales and profit margins.
Foshan Ragos NC Equipment co.,LTD. emphasizes our commitment to quality in our laboratory and R&D services.